Key Our Cars

Just a quick pic (poor quality due to using my blackberry as a camera) of the double deck addition to the gaming table. That’s my wife holding the light in place for the picture purposes as it all needs to be actually assembled and finished before I can screw that down.

It’s constructed of two sheets of 1/2 ’smooth one side’ or rought craft grade plywood.  I went cheap here for a couple of reasons, one they didn’t have 1/2 oak or birch plywood at the store, I’d of had to order it special and I didn’t want 3/4″ as it was too thick.   Two, the top piece is going to be covered in something with a plexiglass mapping sheet on top of that so good wood would have been wasted.   The bottom piece I’m going to paint white for light reflecting purposes so again we’re wasting good wood under paint.

Now the center piece that separates the two pieces of plywood I did make out of oak, primarily for strength and just because I was able to get precut pieces that are perfectly square which makes the parts go together stronger.

The two sheets of plywood are exactly 35″ by 64-3/4″ and fit inside the well in my gaming table with about a 1/16″ gap on all sides to allow for expansion and easy removal.

I’ll be screwing the center divider down onto the lower piece of plywood.  The top will be attached to the divider by a peg and wedge system so that I can take it off easily just in case.  I’ll attach some 2x blocks of oak to the underside of the top that will fit inside the divider snuggly and then drill a hole through the divider and into the blocks and use pegs to affix them to each other.

The reason I want to be able to take it apart is I’ll be mounting a power strip inside the divider and running the wiring into it so there’s only one cord coming out of everything to power the lights.

The light is a cheap little 24″ flo I got at Lowe’s for $9-$10 as a test to see if it works well enough.  It’s not actually that ‘hot’ a light, the picture just contrasts it that way but still I’m not sure if I’ll be adding one to each location or one to each side.  (4 lights versus 6).  6 would work ‘best’ but not sure if it’s necessary until after I get the wood painted white and see how it all reflects.

Anyway, that’s what I’ve been doing with my evenings the last couple.  Working with wood is a slow process as you’re always waiting for glue or stain or poly/varnish to dry before you can continue working and those generally run into the 24 hour blocks for best results.